Functional polythiiranes 7: Surface activity of polythiiranes with PEO side chains

 Some comb-like polythiiranes with PEO side chains were prepared from the corresponding macromonomers. These new materials are amphiphiles and act as surfactants. Their surface tension and interfacial tension are measured and studied in this paper on account of their structures. The lowering of surface tension measured in polymers bearing methyl terminal group in PEO side chains, are in the same range as these observed with polymers of identical structures but different main chains. An increase of the hydrophobic units in the main chain, obtained in copolymers with methylthiirane does not significantly modified the surface tensions. Better lowering is afforded with structures bearing large alkyl groups as terminal group of PEO side chains. On the contrary, some of these macro-molecules with an optimized EO content largely lower the water/xylene surface tension. The main interest of these new materials is their very low cmc and the stabilization of L₁-type microemulsions. Received: 20 May 1997 Accepted: 25 November 1997     

有机膨润土的吸附性能研究

有机膨润土处理水中有机物的研究已有报道［1－4］，但尚无就改性所用的表面活性剂对有机膨润土吸附性能的影响及规律的系统研究，对有机膨润土与不同有机物间作用机理的报道也甚少［1］．本文用3种不同的阳离子表面活性剂改性膨润土，并从等温吸附线的特征和有机物的辛醇－水分配系数较系统地研究了有机膨润上对几种有机物的吸附性能和作用机理．1实验部分1．1材料原士为钠基膨润土，经测定其阳离子交换容量为7464meg／100g土；澳化十六烷基王甲铰（CTMAB）为分析纯，溪化十二烷基三甲铰（DTMAB，95％），演化十八烷基三甲按（OTMAB…     

A 1H NMR study of 1,4-bis(N-hexadecyl-N, N-dimethylammonium)butane dibromide/sodium anthranilate system: spherical to rod-shaped transition

The effect of addition of sodium anthranilate to 5 mM micellar solutions of gemini surfactant 1,4-bis(N-hexadecyl-N,N-dimethylammonium)butane dibromide is investigated by ¹H NMR. The solubilization site of anthranilate anion near the micellar surface is inferred. In the micelles, the An⁻ ions intercalate among the surfactant headgroups producing morphological changes.     

The Interactions Between Nonionic Surfactants and Cyclodextrins Studied by Fluorescence Measurements

The complex formation between some nonionic surfactants and -, - and -cyclodextrin was studied by fluorescence measurements. The relative fluorescence intensity of a solute containing a nonionic surfactant at a constant concentration far below the critical micelle concentration (CMC) are enhanced by the addition of cyclodextrins. Non linear type equations were derived to obtain stability constants by fluorescence measurements for inclusion complexes formed between cyclodextrins and the nonionic surfactants. In most cases 1 : 1- and 2 : 1-complexes (ratio of cyclodextrin to surfactant) are formed.     

Characterization and quantitation of mixtures of alkyl ether sulfates and carboxylic acids by capillary electrophoresis with indirect photometric detection

The separation, characterization, and determination of mixtures of alkyl ether sulfates (AES) and fatty acids (C10-C16) in background electrolytes (BGEs) containing acetonitrile (ACN)-water mixtures is addressed. Due to inhibition of the ionization of the carboxylate groups, the migration time and the resolution between the fatty acids decreased when the water content of the BGE was reduced, but efficiency and resolution between the AES oligomers improved. The migration times increased and resolution improved by substituting 5% ACN by an equivalent amount of dioxane. A complete separation of the two surfactant classes, up to the AES oligomers with 8 ethylene oxide units (EOs) with respect to C10, with excellent resolution between the AES oligomers, while preserving a satisfactory resolution between the fatty acids, was achieved with a BGE containing 5 mM trimethoxybenzoic acid, 7 mM dipentylamine, 85% ACN, 5% dioxane, and 10% water. The two surfactant classes were increasingly resolved by further reducing the water content of the BGE. Thus, C2 (acetate) was resolved from the AES oligomers up to 7 EOs using 90% ACN and 5% dioxane, but the resolution between the heavier fatty acids was poor with this BGE. Identification of the AES oligomers was eased by the excellent regularity of the successive migration times; thus, within each AES subclass or series of oligomers with the same number of carbon atoms in the alkyl chain, the migration times decreased following a mild curve as the number of EOs increased. The way how the data obtained by indirect photometry (corrected peak areas that are proportional to the molar concentrations) should be managed to avoid systematic error when the calibration curve is constructed using an AES standard with an oligomer distribution different from that of the samples is discussed and equations are given. Decyl sulfate was successfully used as internal standard. The detection limits (S/N = 3) were of ca. 2 microM for individual AES oligomers.     

Evaluation of the factors affecting extraction of organic compounds based on the acid-induced phase cloud point approach

On the basis of a better analytical exploitation of acid-induced cloud point approach, a systematic study on the phase behaviour of acid aqueous solutions of anionic surfactants and factors affecting anionic surfactant-mediated extractions was performed. The anionic surfactants investigated were alkylsulphonates (ASS) with alkylchain lengths comprised between 8 and 16 carbon atoms. The critical hydrochloric acid concentration (minimal acid concentration required to separation in two liquid phases) was found to increase as alkylchain length of the anionic surfactant increased from 10 to 14. Non-acid-induced liquid-liquid phase separation was observed for sodium octanesulphonate (SOS) or sodium hexadecyl sulphonate (SHS) in the hydrochloric concentration range 0-10 M. Acid aqueous solutions of sodium decylsulphonate (SDeS) and sodium dodecylsulphonate (SDoS) separated into two liquid phases at temperatures ranging between 10 and 80 °C, while temperatures >35 °C were required for sodium tetradecylsulphonate. The influence on extraction efficiency and concentrating ability of experimental variables such as hydrophobicity and concentration of surfactant, nature and concentration of analyte, hydrochloric acid concentration, time and temperature of extraction and time of equilibration and centrifugation was examined. Advantages provided by anionic surfactant-mediated extractions over the use of non-ionic surfactants (cloud point extractions) are discussed.     

Effects of nonionic sugar surfactants on the phase transition of DPPC membranes

The influence of newly synthesized N-alkanoyl-N-methyllactitolamines (decanoyl [C₁₀MELA], lauoroyl [C₁₂MELA] and miristoyl [C₁₄MELA]) on the thermotropic phase transition of phosphatidylcholine bilayer was compared with common sugar-based surfactants N-dodecyl-β-d-glucopyranoside [C12G1] and decanoyl-N-methyl glucamide [MEGA-10]. The results indicate that C_nMELA are very active at the membrane surface and disturb the phospholipid bilayer structure less than commercially used MEGA-10 and C12G1.     

Sorption/diffusion behaviour of anionic surfactants in polyacrylamide hydrogels: from experiment to modelling

The sorption and diffusion processes of anionic surfactants with different chain length through polyacrylamide hydrogels with low swelling degree have been studied by electrical conductivity measurements. The multicomponent equilibrium equation has been used to model the sorption isotherms of different anionic surfactant in the hydrogels. Such isotherms show that initial rapid sorption of unimer surfactant into the membranes occurs, suggesting that non-freezing water can be involved in these interactions. In aqueous solution, at concentrations near and above the critical micelle concentration an anti-co-operative region is found. The diffusion coefficients of the anionic surfactants inside the hydrogel matrix show that the mobility of diffusing surfactant entities is dependent on cross-linker concentration and chain length. The Cukier hydrodynamic model and the free volume theory as modified by Peppas and Reinhart were applied to explain the dependence of the diffusion coefficients of surfactant on surfactant concentration inside the hydrogel. The hydrodynamic model was applied with success to the more hydrophilic surfactant, sodium 1-octanesulfonate, showing that the diffusion coefficients, D, increase when the resistance to hydrodynamic medium decreases; when the surfactant chain length increases (sodium dodecyl sulfate and sodium 1-hexadecane sulphonate) the variation of D with the free volume can only be understood considering the sieving effect produced by the surfactant inside gel.     

Rheological properties of the aqueous mixtures of cationic-anionic surfactants

The rheological properties of the aqueous mixtures of cationic-anionic surfactants, both in single-phase systems and in aqueous two-phase systems, have been studied. Bizarre rheological properties —negative thixotropy, viscoelasticity and hihg viscosity of shear rate dependent at relatively low concentration — have been observed. An unusual viscosity change, that is, viscosity lowering with increasing concentration, was obtained. The negative thixotropy might be due to the existence of lamellar or sheet-like micelles, viscoelasticity might be induced by rodlike and lamellar or sheet-like micelles, the high viscosity might be a consequence of the formation of network by long rodlike micelles and the concentration-induced viscosity lowering could be interpreted in terms of the decrease of micellar dimensions with concentration.     

Impact of micelles on the biocidal efficiency in a diesel–water interface

Biodegradation occurs in the diesel/water interface in petroleum product pipelines. The microbial contamination can result in inhibitor/fuel degradation, leading to unacceptable levels of turbidity, filter plugging, storage tank corrosion and stored product souring. Therefore, selection of the biocide/inhibitor plays an important role in the transportation of petroleum products through pipelines. Three biocides (cationic and nonionic) were employed to study the biodegradation in a diesel‐water interface. The biocidal efficiency against degradation of diesel was examined by employing Fourier‐transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (NMR) spectroscopy and gas chromatography mass spectrometry (GC‐MS) techniques. Bronopol (2‐bromo‐2‐nitro‐propane‐1, 3‐diol) was found to have higher bactericidal efficiency than N‐cetyl‐N,N, N‐trimethyl ammonium bromide (CTAB) and cetyl pyridinum bromide (CPB). But the cationic biocides (CTAB and CPB) showed good biocidal efficiency at the interface. The data are explained in terms of a model that postulates the formation of a ‘micelle’ at the diesel‐water interface. Copyright © 2007 John Wiley & Sons, Ltd.